I rid my area of five of these critters last year: Two shot, and three trapped. Haven't seen any around yet this year. Yet.
If you haven't had any luck shooting them (or if you have close neighbors or some other reason that gunfire just isn't safe), the best way I've found is trapping them.
Go to the link below and look at the Bridger body traps. I think you'll want either the 6" (#160) or 7" (#220) traps. If groundhogs are that much of a problem on your spread, you'll want to buy *at least* a half-dozen traps.
First, attach the trap to something reasonably heavy so that it won't get dragged off; I use an old bush-hog flail and some worn-out tire chains. Now, set the trap -- but watch your fingers!
Next, place a trap over every burrow you can find. Some of them are woodchuck residences, and others are just places they dig so that they have somewhere to go hide if they sense danger.
Finally, camouflage the trap with a few handfuls of fresh-pulled blades of grass, but leave the opening visible.
With any luck, the traps will spring when the intended target either pokes its head out of its burrow to go and maraud your vegetable garden, or rushes back into it when fleeing danger. (O, the irony!) The traps usually catch them across the waist and chest, and the end comes rather quickly.
I then take the carcasses some distance away (onto a powerline that runs parallel to the property line) and leave them belly-up. The crows or coyotes/other scavengers do the rest.
I like using the traps, as they avoid the use of poisonous methods and are much more discreet than gunfire.
Good like with your campaign, and let us know how you make out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
