We have a Co-op here and as such we own part of the company and have votes to clear out anyone that gives us trouble. It makes for a nice setup between us and the power company they are real nice about anything they do on your property. I call them every once in a while to clear the limbs around my power line coming into the house, they are alway very nice even do more than they are required just because they are there and you want a limb or two extra cut for safety or looks. I have three lines on the property that cross it they have right of ways but will not come on your land unless its an emergany or they get permission first. A while back a tree on my neighbors property was almost on the power line after a strong wind they came when I called but wanted to know if I had the authority to Ok it. I said the owner was gone and I had the right to give them permission to cut it down. It would have knocked out power all around us as it was a main line. I really like our Co-Op they are all real nice people to deal with. When I bought the house I hooked up my 220 table saw to the 200 amp service that the last owner had put in. When I turned it on the lights went out and the saw took several seconds to start. So I called them and they looked up the house on their computer and said that it had a very old and small transformer, they were out the next day to replace it. Walt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.