Posted by John T on June 04, 2008 at 17:52:48 from (66.244.97.31):
In Reply to: polarizing generator posted by Dan Nederhoff on June 04, 2008 at 15:55:52:
To Polarize use a length of wire etc to momentarily flash/jump from the Voltage Regulator's BAT terminal over to its ARM/GEN terminal and you ought to get a small spark. If the VR's ARM/GEN terminal is hard to get to simply jump from the BAT terminal direct down to the Gennys ARM post. If the VR is hard to get to period, jump from any hot ungrounded battery voltage source such as where the big batetry cable atatches to the starter switch or solenoid down to the Gennys ARM post. Of course, this works for Pos or Neg ground, thats the whole purpose of doing all this so the genny starts charging at the correct polarity and you dont let the smoke out of the VR.........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.