Regardless of what some other people are telling you - there are many laws in many states that require you to pull over and let traffic pass - when possible in certain situations. I can't comment specifically on your area.
Here's a section from Montana highway law - and I know - at the least, New York, Michigan, and New Jersey, and Pennsylvania have the equivalent.
This is from public highway law concerning slow moving vehicles:
" . . . on a highway that has only two lanes for traffic moving in opposite directions, when an overtaking vehicle being operated in conformity with does not have a clear lane for passing as required by , the driver of a slower-moving, overtaken vehicle shall, at the first opportunity and when a safe turnout exists, move the overtaken vehicle off the main-traveled portion of the highway until the overtaking vehicle is safely clear of the overtaken vehicle. On an interstate highway or on any other four-lane highway, a slow-moving vehicle, subject to the requirements of this section, must be driven in the right lane as far to the right as possible, including the shoulder of the highway
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
