Posted by snitkawl on May 31, 2008 at 17:43:40 from (75.121.248.80):
In Reply to: O/T Wood value posted by Devin Sparks on May 31, 2008 at 07:35:48:
I am posting this at the top of the thread for visibility. Responding to the post below, I shot off my keyboard(same as shooting off ones mouth, only different). I called a friend who has been in the business of producing walnut logs and lumber for about 35 years and ask him about "stretching grain". He said(as I thought) that grain does not stretch, however, what does happen when a tree is felled improperly, long splinters are pulled from the log, destroying its veneer quality. My comments below were not meant for Mr. guru, but for whoever gave him the misinformation. On another note. Mr guru, do you have any idea where I can obtain a hammer spring for a model 90 Winchester?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.