Posted by B-maniac on May 25, 2008 at 20:04:30 from (207.241.137.117):
And we are talking 1976 !!! I'm sure many of you remember this. At least that's what they got up to here in MI. Had nothing to do with supply and demand and nothing to do with greedy farmers or middle men or truckers or any other working class people! Two words...COMMODITY TRADERS!!!! Still want to blame the oil companies , go ahead , they have commodity traders working for them. If it was as simple as supply and demand then every oil drilling company with rigs and men would be drilling everywhere. They were drilling all over in the '70s when oil was only bringing $30 a barrel. Now it's over $120 and no one drills??? Because THEY know it is not a supply shortage driving the price. Just like beans came back down to $22 in less than 3 mos. , they could set up all their rigs and by the time they got through the permit red tape and had all the expense tied up the bottom would fall out just like it did the bean prices after a ton of farmers went out and bought brand new tractors. The stock market and commodity traders are a part of our American free enterprise system that LEGALLY can bankrupt this country for the greed of a very few. Why isn't oil controlled the same way natural gas is?? It is not a commodity and not traded and the price cannot be raised without the OK of a commission that must first see proof of need in order to get a price hike. Natural gas is in no way linked to a barrel of crude but you can bet your @ss if it weren't for regulations they would be right up there with gas prices for one simple reason "BECAUSE THEY CAN"! It's the system that needs changed , but there are too many fat cats and wanna be fat kittens that like it the way it is for that to ever happen . They ALL have their price and they all can/will be bought!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
