Posted by francis p on May 22, 2008 at 19:42:10 from (75.49.117.110):
all was turning well after the crank,rods and head were assembled,the crank was newly reground,assembly was done with stp oil treatment,and some mell motor build lube mixed,as we were stabbing the engine,both clutches were aligned ,both went in ok as well,thenm the flywheel also went in,thats clearly visible thru the bottom open hole for adjustments,nothing looks bent or torn up,,as the bearing and pilot shaft were aligning,it started to get harder to put in,but it went,it seems the last 1/2 inch was the hardest,but it all went together,it seems that when i bumped the starter,it mnade a little hop,but then again 1 battery is a little low,could my starter be the problem?or could it be this may be the way they just fit together after being separated?the flywheel is still movable up to 2 teeth thru the timing hole at the side of the tractor also underneath,i did notice that the flywheel has been engaged or it is stuck with the 3 prongs inward also,could this be the reason why its hard to turn over right now?i think i'm going to pull the starter back off,maybe its hung,but all shafts went into place too as this 6030 was being rejoined at the cab area,any thoughts on what could be holding up?thanks in texas,maybe i'll just sell my old toy,but i kinda like hearing it run too
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
