Avery, Your cultivator comes off the tractor in pieces. It's not likely it was disassembled any further - but that's a guess. You should have at least: 2-front mounting frames (square stock) each of which will probably still have two sweeps or equivalent width plows attached. 2-rear mounting frames probably with a single sweep attached to each (they run behind the rear wheels). 2-rear spring-loaded shafts. 2-front spring-loaded shafts (heavier construction). If you got planter equipment there will be more stuff, not needed for cultivation.
One IH cultivator for a Super-A is: McCormick A-144 Corn and Cotton Cultivator. You might find a mention somewhere in these archives where a manual can be obtained (it's not just for corn & cotton only).
The cultivator has what IH calls a universal mounting frame for a SA, one for each side in front (they mount in the square holes under the tractor front) and one on each side in the rear where each bolts on the drawbar (it's removed) mounting bolts and has a vertical spring-loaded connector rod hooked into the rear rockshaft holes. The front frames connect to the front rockshafts on each side with spring loaded shafts. With these clues, you can probably 'wing it' after looking the parts over. Hope this helps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
