Tractor Talk Discussion Board |
Re: Plowins fun!
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by john d on January 22, 2000 at 12:57:02 from (206.141.74.34):
In Reply to: Plowins fun! posted by Levy on January 21, 2000 at 20:32:47:
If you're talking about the "Lift-all" system, or "belly pump" hydraulics, it's pretty straightforward. First remove the pipe outlets, the filler cap, and the control lever. Then remove the cover at the back of the pump on the bottom of the tractor, which lets you have access to the drive coupling. The pump is supported by four bolts on the bottom. Now....a word of caution is appropriate here! That pump is heavier than it looks! You may be strong enough to one-hand that thing out of there, but odds are against it! Either get some dependable help, or lower it by using some pieces of threaded rod and nuts in place of two bolts on opposite corners. There are other ways to handle it, including supporting it with a bar through the cross-hole in the very bottom of the casting. However you decide to lower it, don't let it take you by surprise!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|