Posted by Dave from MN on April 27, 2008 at 05:12:44 from (74.60.86.134):
well 4 down 2 to go. So far 1 black bull calf. 1 solid black heifer and 2 solid red heifers. All I have left to calve is that shorthorn/angus and an angus/pinzgaur. Was quite the adventure trying to get the one born yesterday in that wind and snow into the shelter. That red angus mama wasnt really amused with me grabbing her 20 minute old baby and walking away with it, actually after 3 steps I was running for my life with it. Loittle girl spent the night outa the wind and rain and is all full energy this am. If this heifer rate keeps up I am not gonna have the 4 steers to feed out like I was planning. I cant bring myself to use them heifers as feeders. In any of your guys experience is creep feeding a good practice as far as calf health and economics are concerned. The 5 day old calves are already chewing hay and looking for things to munch on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.