You apperantly haven't spent much time operating tractors that dance on two wheels. I've done a lot of it. Some by necessity and some for the sake of it. I mostly learned to drive by hauling 1000-1200# round bales on a spike hitched to a Ford 860. Many a trip was made in reverse up a hill and many more were headed down hill with the front wheels in the air, steering on the brakes. The worst thing that was going to happen is that the bale would hit the ground, bounce and the tractor would settle down... or if it was a real heavy one I'd have to let the bale down, back up and spin around again. I did hundreds of hours of that. There are very few situations where the tractor will pass it's balance point on the rear axle before a three point load touches the ground, so I don't expect that the linkage would need to support the weight of the tractor. You are no doubt correct that some would fold up quite easily under that kind of weight if they were placed in a situation where the weight of the tractor was placed upon them. Most that I deal with would not. That would depend entirely on the tractor.
ROPS will not prevent a tractor from flipping over. They will probably prevent someone from being killed if they do flip it over provided that they're wearing a seat belt.
Tractors are only lumps of iron. They can be controlled. There's more value in learning about what they can do rather than worrying about every stupid little thing that could happen. Popping a wheelie on an old tractor is not something to stain your pants over. It's pretty normal, really.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
