Posted by D Slater on April 18, 2008 at 15:16:46 from (71.164.39.153):
In Reply to: 1950 MD posted by Dale Self on April 18, 2008 at 14:36:15:
I don't know how you checked compression on gas or diesel side. You can tell if the starting valves are leaking in the cylinders by cranking engine on diesel side with gauge in spark plug holes. If no starting valve leakage there won't be compression. Another sujestion is to remove the injectors one at a time and turn injection line to install injector outside head with bucket under it and check spray compared to a cylinder not missing. You may also be able to get a idea if its a injection pump problem by cracking bleaders at injectors while running. Also if its 2 cylinders on front or rear check for proper operation of butterflies in intake manifold. Also the running valves could leak or cam and valve opening parts problem, low compression from rings cylinder wear, bad head gasket. To check compression on diesel side requires doing it at the injector holes. Sorry for stating that if you already did this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.