There's a crush sleeve between the two Timken bearings. When the rear end is assembled, the bearing preload is set by tightening the pinion nut and checking the preload with an inch-pound torque wrench. If you've got an eighth-inch of play, I imagine your rear end is making enough noise that you're having a hard time turning the radio up high enough to mask the rear end whine.
The "right" thing to do is to tear the rear end down, replace the bearings, set up the pinion preload, ring gear backlash, etc. But you probably don't drive this vehicle enough to justify a $500+ rebuild. You should be able to tighten the pinion nut a bit and get by. It takes very little movement on the nut to take the slop out of the pinion bearings. Tighten a 1/16 of a turn at a time and check to see if you have a little preload on the bearings. As soon as you feel a little resistance when you try to turn the pinion by hand, stop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.