Posted by Nolan on April 01, 2008 at 17:59:00 from (216.52.245.38):
In Reply to: rust removal posted by ken in texas on April 01, 2008 at 13:10:53:
I"ve done it. It"s slow, it"s messy, and good lord does it stink!
Dumping the feed molasses into the tub just creates a thin soup of sediment. When you drop a part into the mix, it gets buried under the sediment and doesn"t derust well. So plan ahead to be able to drain the liquid off into another container, leaving the sediment.
It does work, but it"s slow. It leaves a heavy grey film on the parts that requires a lot of scrubbing to get off.
After a few weeks, it starts to grow a very stiff thick blue/green/white crust that stinks worse than a rotting animal. When you reach your hand through this mess to grab out a part the stink soaks into you and doesn"t wash off worth a darn for a day or two. So don"t grab parts and then try to eat lunch. Reverse that order.
After a few months it quits growing mold, doesn"t smell as bad, and seems to quit working.
It is worthwhile when you just want to throw a rusty cylinder head into a tub and ignore it for a few weeks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
