Posted by Kelly C on March 28, 2008 at 08:22:43 from (75.168.42.90):
In Reply to: farmall re-build posted by Farmall Flunkie on March 27, 2008 at 17:59:33:
What Farmall you rebuilding?
Dont order the kit until you know what you need. I ordered mine early with standard bearings and ended up ordering undersized after I got it all apart.
If you are doing a inframe. Pull the pan and measure the rod jurnals and the main jurnals. I know on a 560,706 gas you can replace the main bearings with out pulling the crank. Just put a brass nail in the oil hole in the crank and turn the crank and the top bearing spins right out.
You need a caliper to do the mesuring. Harbor freight has them for like $20. Hard to mesure the mains with the crank in though. Also check the tapper on the jurnals. If one side is wore more than the other or out of round. You will need to pull the crank and get it reground.
On mine the #3 rod jurnal was plum wore out. Had to get it built up and reground. I ordered the proper bearings from the guy who ground the crank.
I would recomend that you buy the inframe kit with out the bearings and buy the right bearings as you need them. its possable you might need. 3 standard bearings and one 10 under.
Just take you time and you will do fine.
If you interested in my engine rebuild learing experience. You can check out my web site. Its in the section for a 706.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
