Lol yes... never seen one come off that hard before. I was not forsure you was going to get it to brake free at all. Also that was about and hour working on that one part. Least it's apart now. Joe on other site mention this .. info
Larry, as near as I can tell from your post you are looking for a clutch plate and a pressure plate, is that right? The shaft that drives off the engine clutch plate is called a "clutch shaft" and sometimes a "engine pto shaft". It is splined at the clutch plate and on the other end (transmission end) just aft of the clutch shaft bearing at the hand clutch pack on your tractor. It appears the vendor is trying to ID the clutch shaft so they can provide a 9-1/4" clutch plate with a spline count & diameter that matches your clutch shaft. The clutch shaft for the 300B series is p/n G10365 before s/n 6097696 and p/n G17201 s/n 6097696 and after. I think the 9-1/4" single clutch plate (standard p/n G11077 or heavy duty p/n G11079)is the same for both but if the vendor can't figure it out from the shaft p/n's go somewhere else. The least expensive repair is to reline if your existing plate is in decent shape. The pressure plate is a different animal, it is splined to accommodate the hydraulic pump drive shaft. I wouldn’t try to do any generic matchup there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.