|
Tractor Talk Discussion Board |
Re: How effectively one can run electric generator by tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Harold New York (USA) on January 07, 2000 at 21:02:17 from (209.139.23.234):
In Reply to: How effectively one can run electric generator by tractor posted by Padmakar Parihar on January 07, 2000 at 05:15:16:
Padmakar-What kind of pump are you operating? Is it (1)a centrifugal pump that sits on the surface and pumps from surface waters or a shallow depth well or, (2) is it a deep well turbine type pump with the electric motor at the surface on top of the well driving a line-shaft turbine or, (3)is it a deep well submersible pump where the electric motor and pump are both down in the well water? If you have either situation (1) or (2) I believe you should consider a direct connection from the tractor pto to the pump. In the case of the turbine pump (2) you would remove the electric motor and replace it with a right-angle gear drive of the proper ratio and then connect this to the tractor pto. If you are using a centrifugal pump (1) then I believe you would do better to purchase a centrifugal pump designed for tractor pto operation; these have the proper gears to step up the speed of the pto. Only in situation (3) the submersible, or if you can't position the tractor next to the pump, or if you are using the electricity to power electric motors for a traveling sprinkler, should you even consider the generator. With a generator you are adding another link that needs maintenance, introduces power losses, and can break down. In any event, if you use this tractor or a newer one and are running it unattended, be sure it is equipped with gauges to shut it down automatically if it overheats, looses oil pressure or the irrigation pump pressure drops suddenly; that is unless you can station someone to keep an eye on it at all times. Good luck in your venture.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
