If the tractor is running, the hitch should automatically re-adjust upward for any settling that may have occurred.
I assume a 4020 JD. There is a cam on the rockshaft and on the cam rides a follower that is connected to the draft sensing linkage. A roller in the rockshaft valve's linkage rides on the follower. If you are set on "D" the draft sensing linkage does not have any effect on the rockshaft valve, only the cam's position can affect the valve.
The valve consists of two balls and seats. One is for raise, the other for lower. The rockshaft valve's roller is pushed back or allowed to move forward due to the cam action as the three point goes up or goes down. Via the linkage that is connected to the roller, the corrisponding ball is pushed off it's seat and allows oil in if it needs to raise, or out if it needs to lower. The cam rotates as it is raised/lowered and when it gets high or low enough, the ball re-seats and flow is stopped. The hitch then maintains that position until it leaks down slightly or until you move the three point lever. The correct ball is then pushed open and the hitch reacts again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.