Adam Sm. If it is a battery Ignition her is the timing steps from my I&T Manual. Crank engine until #1 pistion is coming up on compression stroke then crank slowley and stop when flywheel mark "Fire" is in the centre of the inspection port. Place distributor rotor in position where metal strip an top is pointing toward battery lead terminal on distribitor body. With contacts set to 0.022 gap, place distributor in mounting bracket and engage the driving members. Now rotate distributor cam as far as it will go in direction of its normal rotation and while holding it in position, rotate the distributor body until the contacts just start to open. Now tighten the mounting bracket to lock the distributor in this position. This method sets the fully advanced or running of the distributor. If a timing light is avalible the timing should be rechecked by running the engine at fast idle (above 1100 rpm) at which time the flash should occur when flywheel marked "Fire" or "F" is centered in the inspection port. Static timing is top center which is indicated an the flywheel by the mark "DC". Hope this helps you out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
