Posted by Larry59 on February 18, 2008 at 16:21:43 from (4.245.3.79):
I have my case 311 B 58. My new dash should be in when I get back home. Now the old sending unit on tractor was just a small round pipe like that screwed in motor and on dash. But the new dash will have an electric reading unit. So I must replace the sending unit on motor to an 12 volt one. So does any unit fit in the motor? Is it special one for a case tractor only? Are does anyone that fits the hole in engine work? Any thing I might need to know more on doing this? Thanks
Answers to this are: 1. You will need a sending unit with the same size pipe threads that are in your engine block. Hal 2. El Toro is correct, the sending unit should be designed for the new gauge. The voltage change curve will be important for accuracy. Adapters can be used to place it in the hole. A supply voltage will also be needed for the gauge. (and sometimes a instrument voltage regulator. JimN
What is a voltage change curve ? Where do I get one and how is it applied
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.