Posted by Dick L on February 15, 2008 at 12:43:32 from (72.11.21.66):
In Reply to: The head posted by Lanse on February 15, 2008 at 12:04:50:
Do you have a 3/4" deep socket? A pipe nipple will do the same thing. If you do set it over the valve end down on the spring and hit the socket a coupla times with a hammer. Try not to loose the keepers but if you do its no big deal. put the keepers, springs, and all the spring retainers in a coffee can. Tap the valves out. (TAP NOT HAMMER) Oil them up good and if they get tight turn the head over and tap them back and forth with oil added as needed. Then get some good pictures of the seats once the valves are out. One picture of each of the four cylinders. Full of rust makes it sound like you have a good or bad chance that the seats are pitted on at least two valves. Hope not but still no big deal if they are. Once you have the valves out and the rust cleaned off the stems and out of the guides you can see if you need new guides. If they are bad I will get a set on order. I am sure you won't find any cracks in the head. That head is one of the strongest heads ever made.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.