I was curious to your opinion on a matter involving a recently poured concrete slab...
We had an 8'x8' slab poured on Monday around noon. Sunday evening the contractor stopped by to lay an insulated(not electric) blanket over the area which I had just cleared. The only thing I know about the mix was that Calcium was added and they used a 'six-bag' rather then 'four-bag' mix. It definately didn't appear to be real runny. I also noticed they did place rebar along the bottom. They formed with standard 2x4's and the drop was no more then 3". They came back that evening around 5pm and put the blanket back on. It remained there until I removed it on Thursday at around 8am.I pushed the little bit of water that was on top(I think it was more likely from precipitation and not so much from the concrete, but I really don't know)off the sides to allow for a little bit of air dry prior to deliver of new spa. I added water to the spa at 5pm. It is currently heating up. The temperature here in SW Ohio has been lows in the teens and highs 21-37 F. The forms are still around the slab, not sure if this is good, bad indifferent. I know I am taking a chance of damaging not only the integrity of the slab but also the structure of the spa if the slab were to give. What would be your overall feeling about my position? Do you think it will probably be fine, or do you think I'm screwed?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
