Posted by 6U684 on February 14, 2008 at 13:26:44 from (67.224.28.37):
Like an enthusiastic "back to the coutry" dummy, I put a good concrete floor in the 40x60 steel arch shed. I can't keep it warm enough to prevent tool rust, the bullet holes leak, my self tap screws from inside light fixtures leak, the sliding door is too heavy for casual use....blah, stupid me. Now I am evaluating whether to build a pole building over the whole shed, or to screw a sandwich of styrofoam, plywood and shingles over the outside and replace the door with an overhead door, narrower but with a pedestrian door beside it. I have been told the spray on foam would cost in excess of $10K. Has anyone seen a better way? I would appreciate your suggestions. Leonard
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.