Posted by ben brown on February 11, 2008 at 17:13:54 from (12.213.80.36):
In Reply to: Taxes and buildings posted by Dan-IA on February 11, 2008 at 15:28:26:
my shop when i first build it starter out 36x30 decide that was not enouh room put 10 ft extision on each side for tool bench office and catch all. so has a 30x36 work space have a 4255 and a 966 doing transmission on the ih and engine overhaul out fram on the 4255 and the 966. is enough room but bit tight have 12 ft hight. now if i was redoing it the first thing would be heat in the floor. if you keep your feet warm your warm. i am building a 40x60 14 ft wall well be for keeping my trucks tractors toys and junk dry. gravel floor right now. my bother in law and i were putting his jeep under the roof {freezing rain right now} still building have roof up no side medaal yet we both looked hell could ues nother 60 ft. some of the farmer i do work with have monster shops sill not enough room i dont think one could build a shop big enough. i would say the 36x30 is bear miniman. now that uesable work area. so you would need more space for what i call good stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.