Tractor Talk Discussion Board |
Re: Welding
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by B.C. on December 28, 1999 at 12:44:29 from (131.167.75.193):
In Reply to: Welding posted by dp on December 28, 1999 at 12:12:00:
Well this ought to get only slightly fewer opinions than religion or politics. It depends on what you intend to weld. If you are going to do plate 1/8 inch or thicker an a-c "buzzbox" should work just fine, up to maybe 1/2 or 3/4 inches of thickness (using multiple passes). This would cover a lot of farm machinery. 6013 (and I think 7024) rods would let you do some sheet metal work but below about 1/8 inch some form of wire feed, tig (usually is expensive) or good old gas torch works better. For he-man welding I prefer DC current and 7018 rods, but ac and 6011 will do in most cases. For steel thinner than that a wire feed of some sort would be better. Or you might consider an oxyacetylene torch setup, which would let you cut thick stuff and weld thin stuff.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|