Posted by trucker40 on January 30, 2008 at 10:30:33 from (69.149.165.118):
In Reply to: Its decapitated posted by Lanse on January 29, 2008 at 19:24:10:
Whatever you use on the rust in the cylinders dont go up and down the cylinder,go around the cylinder.If you cut grooves up and down it will burn lots of oil.Steel wool might not do much so you get sandpaper or somthing,then think its easier to sand up and down in the cylinder.Dont do that.Sounds like it maybe isnt stuck too bad but you could push sleeves and all out now with the head off.You can soak it easier with penetrating stuff now.You have to be carefull with the sleeves if you push one out and beat on it,they are brittle and break kind of easy.Another thing they do if you beat on them is they look ok but as soon as you get it running a hunk falls off of the top and ruins a piston.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.