Posted by Ron Bywaters on January 16, 2008 at 21:22:16 from (58.167.237.63):
We are planning a trip to drive several chamberlain champion tractors across the USA. Our plan is to obtain covered wagons as used by the early settlers,but converted to pneumatic tyres,and hopefully follow some of the original wagon routes in our travel across from the East to the West coast.The time frame would be in the summer /autumn of 2009 for 3 months. We are seeking some help however in matters such as the requirements to have the tractors licensed to travel on the various road systems. Advise on the most practical route to take , where and when we could participate in local tractor shows and a host of otherfactors that need to be considered. Ifanyone can offer some assistance it would be very much appreciated. During August /September 2007 we drove a single chamberlain tractor around Australia in 38 days, a distance of 15,000 klms. If of interest,you can follow the journey on the websiteas shown below. Loking forward to hearing from any interested parties . Regards Ron. www.tailendcharliethetractor.org
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
