Posted by super99 on January 12, 2008 at 11:30:39 from (75.107.167.170):
A week ago, I used my 400 Farmall and let it run for about an hour since it hadn't run in a month or so. Tuesday nite I went out to start it, it turned over but wouldn't fire. It was drizzling, and I thought it was just damp and would start when it dried out. Tried Wednesday, clear out, same thing. I did some checking with my tester and there is power at the resistor before the coil and power going into the coil, but no power coming out of the coil. The general answers from here were to change the points and condensor. I put new points, condensor and rotor in this morning, and no fire at the points. I am guessing that the resistor before the coil is to change it from 12 volts to 6 volts? Is this right? The test light is brighter on the inlet side of the resistor than the output side going to the coil. What is the next thing to try to get it to fire? Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
