Davis In SC said: (quoted from post at 05:16:11 01/08/08) OK, Polycarbonate is much tougher than acrylic, but PC is much easier to scratch, and cannot be exposed to any oils or other hydrocarbons. Just an oily fingerprint will cause PC to stress crack.
Acrylic is much harder, and does not scratch easily. But on the flip side, it WILL shatter on impact.
I dont know about the fingerprint deal as my arm guards were used on sprint cars and they held up to all kinds of oils etc. I will say that I did use GE product only but things like Acetone etc will absolutely destroy Lexan! Like I said, we need to know your application to determine which is best.
I had a few that cracked on my products but most of them broke due to improper installation. Only use a UNIBIT to drill holes in them. A regular bit will leave stress risers etc. and lead to cracking. I had another come apart 1/16th inch thick when 1/2 a brake rotor smashed into it at 100+mph. I was scared to death the driver got injured really bad but when I got to the pits he thanked me like crazy! He thought he was going to get killed by the rotor coming at him but the Lexan absorbed the blow and saved at a minimum a broken arm. He said that his normal fiberglass one would have just let the rotor through will little loss of energy and would have probably put him in the hospital!
Lexan is TOUGH stuff!
Joe
PS. You can flame polish Lexan by using a propane torch and lightly heating up the lexan. Practice on a piece you dont need until you get the technique down. Just scuff up some scrap pieces and place the flame near the lexan without actually touching it and keep the flame moving. You will see the scuff marks disappear. If you see it bubble you got the lexan too hot!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
