Posted by kyhayman on January 04, 2008 at 09:51:44 from (75.104.128.37):
In Reply to: hydraulic pipe work posted by pete trussler on January 04, 2008 at 09:16:14:
I bought a 7610 orchard model that had been used by a mowing company with a mid mount tiger boom and front hydraulic pump. The setup they had on it was with an auxillary hydraulic oil tank mounted in place of front weights and another on the offset for the mower.
I'd be concerned about plumbing directly into the tractor system to feed an aux pump. Thats a lot of extra heat from the pump and whatever its running that would be dumped right back into the main system. I dont know about a 4610, if it has a hydraulic oil cooler or not but for sure I'd want one on whatever my return line was. For example, its unreal how hot, how fast the hydraulic fluid gets on my skid loader where a common resorvoir feeds both the main drive pump mounted on the back of the engine and the lift and tilt pump on the front as compared to in my dozer which has two resorvoirs, one for each pump.
With that said, if you dont think heat will be a problem I dont see why you cant plumb into the transmission drain plug for inlet and then back into the transmission fill plug for return.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.