There's LOTS of inaccuracies in that article, when you view the state as a whole.
The area covered in the article is the SW corner of the state, which has always been more sparsely populated and tenuous, with dryland ranching more common than crop farming. The eastern part, the Red River Valley, in particular is doing VERY well.
ND has actually be GAINING a (little) population, in the last few years, (albeit mainly in the eastern cities) for the first time in DECADES.
A similar article was published in the September 10, 2001 edition of Newsweek, "Death of a small Town". I am the "Bob" featured in THAT article, and, like this latest one, there was more doom and gloom than necessary. (They took a fair amount of "literary license" with the interview they did with me.)
The article probably would have recieved MORE attention and rebuttal if NOT for the events of 9-11, just one day after the cover date of that issue.
Our town is actually GAINING population lately, with a couple from California, and a number of folks from Wisconsin having moved up here for a reasonably-priced retirement. All the vacant houses available have been sold, with the exception of a couple. Maybe it's not a "boom", but seems to be a good "marriage" between folks looking for reasonable accomodations, and the survival of the town.
There's a pretty good editorial rebuttal to the National Geographic article in a recent issue of the Grand Forks Herald. I will post a link later, if I can find the article viewable on the 'net for free.
With the recent high oil prices and farm commodity pries, and the wind farm development in the state, things actually are looking BRIGHT ('til the oil and grain markets crash, AGAIN)!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.