Posted by Jim in NY on December 20, 2007 at 20:03:41 from (206.15.138.108):
In Reply to: OT, GMC Question posted by Red Dave on December 19, 2007 at 04:34:12:
Sonds like the fuel pump.... heres what a Mechanic friend of mine does in his checks for pump operation 1) turns the key on , gets under the auto and uses a stick(stehoscope) to listen for the pump humming sound, 20 if he cannot hear it he raps real hard on the tank and most of the time the pump will start up and if it doesn't it's bad anyways, 3) if it is pumping to begin with he then checks the pressure at the regulator rail and the filter, 4) if pressure is good and it stays for 12 hours give or take, he checks the regulator for faults..... most of the time the pump is not running when checked underneath and as soon as he raps on the tank and it starts up he calls the customer and tells them of what the expense "may be".. becuse it can be involving i.e. fittings, sender , ect. may want to begin with currrent at the pump and filter ?good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.