Posted by JML755 on December 20, 2007 at 07:57:44 from (66.184.63.107):
In Reply to: At post office today posted by poogie on December 19, 2007 at 17:57:33:
poogie,
If I'm not flying by at 70mph, I usually try and OFFER help. Many times people don't want it, sometimes they look nervous. Doesn't matter, at least I offered and I don't feel offended if they refuse.
Last year, funny thing happened. Noticed a minivan in the ditch of the cloverleaf entrance ramp of the freeway. A young man was trying to jack it up. Pulled over on the shoulder, offered help. He was polite and grateful. He had broken the bead when he slid off the curved ramp (probably going too fast). I said let's get it out of the ditch back onto the shoulder to change the tire. While I was on my back hooking up my chains to his underbody, I heard a "What's going on?". Looked up to see a State Policeman. Kept working and said "just pulling him out of the ditch". Officer said "Stop and get up". I got up. He walked over to the kid, asked if he was armed (he said no) and started to frisk him. Now, the kid was as nice and polite as I was, but the officer must have sensed something. Asked him if he had a record (yes, he was on parole for b/e). WOW, I thought. Officer asked if he could look in the van. Kid said "sure". Cop stuck his head in the van and came back out with a joint and a baggie. Told the kid to turn around and kneel down and slapped the cuffs on. Told me to leave as "this was his van now". Don't know why the cop zeroed in on that kid. Heck, I think I looked more nervous than the kid. Kinda felt bad for the kid as he was as polite and friendly as could be.
Anyway, I still stop and offer help if I can, especially if I'm in jeans and in my truck with tools. I'd like to think someone would do the same for my wife and/or daughters.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.