Long as he didnt hook another tractor or something on it and try and pull it he might be alright. I am a diesel mechanic and I have seen bent rods and bent valves but it was when timing gears broke,or somebody pulled a truck with water on top of the pistons. I would be tempted to try and turn it backwards slowly and see if it pushed out the water.If it got tight you would stop,maybe go the other way then. Its not as hard as you might think to bend a rod,but its only going to be 1 or 2 cylinders at the most with water on it unless the valves are burned out.Anyway bending 1 rod wont keep it from running,it will make it miss real bad.Bending 2 rods it might not run if its a 4 cylinder but I think thats a 6 cylinder so it would probly run,not real good. Just my opinion,might not be right.As for it not running,its not going to run good at first because you cant get all of the water out I dont think anyway.You get enough out it will turn over,but some is still going to be in there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.