|
Tractor Talk Discussion Board |
Re: Re: Confused on coil
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by MikeH(Tx) oops on December 07, 1999 at 18:56:22 from (208.2.106.24):
In Reply to: Re: Confused on coil posted by ltf in nc on December 07, 1999 at 18:40:29:
Sure you didn't get it backward? The resistance from the secondary to common ground is LESS than the resistance to the primary tap because the latter includes both the secondary resistance and the primary resistance. The points should attach to the lowest resistance tap. However, with a 50:1 winding ratio, I am skeptical as to whether you can see the difference on an ohmmeter. 2% of scale if windings are same diameter (and usually they are smaller on the secondary making this measurement even harder to see). Probably one reason why they are marked. I too appologize for complicating what looked like a simple question. However, this isn't a simple question and debate like this adds to our understanding. For the practical, there were several references to the idea that although one way is better, either will work. So, we can debate correctness while Mack fixes his tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
