supergrumpy said: (quoted from post at 10:43:41 12/10/07) they sure took a long time with that trial, just went to the jury last week I think
that sort of thing gives honest law abiding Canada a bad name
Sadly, our once revered and respected national police force has stumbled from disgrace to disgrace the last few years. Allegations of incompetence, corruption, pension fund fraud, human rights violations, substandard training, and terrible morale have many Canadians hanging their heads in shame when the subject of the RCMP comes up.
Thousands of front line officers are fine, fine folks, but the seemingly unending revelations about decades of rot at the top are incredible. Things got so bad for a while the force was stripped of its intelligence arm by the government and forbidden to do work in that area. Of course the new replacement intelligence organization CSIS and the RCMP then did little but squabble amongst themselves and refuse to collaborate or share vital info while terrorists and other scumbags roamed (and roam) free.
So, we're far from squeaky clean up here under all that white snow but maybe now that the past Commissioner is out on his a$$, the rebuilding can begin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
