Older brother works for auctioneer, younger brother and mother used to go to various estate and quitting farm auctions, got some fair deals but some people thought they had inside info from older brother and would outbid them on some stuff that wasn't in best shape, griped later. Older brother and younger brother were fueding a lot so no favors given. Mother got good, not outrageous, deal on JD60, younger brother got Ford Escort diesl when deceased nephew couldn't demonstrate it would start without being pulled 1/2 mile. Brother talked to widow that told him it always started for husband- just had to turn key and wait a minute until dash light changed to 'start'. Figured it was glowplug like IHC 560, got the bid at $200.00- just over salvage mans bid- got in and turned key to preheat, waited minute, little orange start light flashed and cranked it 3 seconds and fired up, drove it home. Couple people griped about $1000.00+ car going to relative of auctioneer crew- were told they could have bid $250 or $300.00 and brother would have dropped out from lack of money to bid higher. Salvage man said he bid for body parts, etc but thought glowplugs might need replaced for about $200.00 to get it to start so not upset. sold brother rear window tail door after back window was broke later. Things happen, do some research and laugh a bit. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.