Posted by Don-Wi on December 06, 2007 at 00:48:19 from (99.139.218.76):
Here's a picture of our loader. It's a Massey 165, with a crankshaft driven pump that is plumbed up to use the rear end as the reservoir.
I'm thinking I'm gonna make up some cylinder stops once I figure out how long to make them, and then I'll be able to disconnect the hoses for the dump and then run lines for angle instead. I can't just connect to the bottom pins and run a chain to the loader frame, because, for whatever reason, the cylinders are on the bottom instead of on top like every other loader I've ever seen.
I've got a lead on a 7 1/2 ft. plow for around $200, and once I get it I'll make up a frame to mount it to the loader, and then hook it up and give 'er a test run. I need angle because I can't just push the snow to the side like most, I have to push it down the driveway and pile it up. No room on the sides to push it otherwise I would.
Need to be able to angle it so I can control how much goes out either side.
If I get bored, I could probably make up some mounts so it can go on the front of one of our other tractors too...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.