Posted by Triplerange on November 30, 2007 at 08:41:11 from (65.173.83.70):
In Reply to: Still thinkin !! posted by TGIN on November 30, 2007 at 03:06:50:
Actually, they don't turn very fast at all. I just watched a professional contractor drill some 24" holes...I'm an engineer...Those pto units are speed reduced...I think about 2:1 or something like that. Your hyd. motor will need to be sized according to your system flow. I've been thinking about your idea though...you could use the bucket cylinder lines and find some hyd. quick connects for the hoses. If you have the model pump you could estimate your flow based on pressure. You'd have to get a gauge and check the pressure of the system. You may be able to get the flow by timing how long it takes the cylinder to go lock to lock...and getting the size of cylinder (length and diameter). Once you know the flow...go online to Parker Hanefin and see if you can spec a hyd. motor per your desired shaft RPM. I think you'd want an RPM of around 200 or so. Then you got to figure out how to mate the motor and gearbox and mount your contraption which needs to be able to bend in both horizontal planes. Hope I've given you some direction....cool project!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
