|
Tractor Talk Discussion Board |
Re: Ford Jubilee ignition timing
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by chuck fischer on December 04, 1999 at 15:45:56 from (152.163.197.189):
In Reply to: Ford Jubilee ignition timing posted by amc on December 04, 1999 at 06:13:18:
the timing marks are on the flywhell, there is an opening in the bell housing, it may have a cover over it. anyway, turn the engine by hand, and using a light watch for some kind of a mark to come into view. the mark might be a zero or TDC or something else, I don't remember. it would be wise to go around a couple of times to make sure you got the right mark. then, with the mark lined up with the pointer in the hole, install the distributor with the rotor pointing to the #1 plug wire position on the dist. cap., assuming the cap and wires are still together in their original positions. if, all the above, there is a 50/50 chance you got it right, engine should start. if it won't start, then remove cap, withdraw the distributor enoughto turn shaft 180 degrees, reinstall, try starting again. no harm will come from putting the distributor in wrong, harm will come to you if while hand turning engine you fail to have the ignition off, it might start or kick back, so pull the coil wire to be safe. if this doesn't work out email I'll try to be more specific, luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
