Posted by 135 Fan on November 20, 2007 at 10:32:23 from (68.149.38.173):
In Reply to: Re: Headache List posted by Allan In NE on November 20, 2007 at 05:24:06:
Possibly a good die grinder with a round carbide burr could grind the weld out but it would take a long time. There couldn't be any weld left that would prevent it coming off. An air-arc torch would work nice but you need a DC welder and an air compressor to use one. You can get gouging rods that are used like a regular welding rod. If you tried to use a hot 6011 or 6010, you'ld probably make it worse. I just thought of an idea. If you have a cutting torch, you could get a gouging tip for it or just use a bigger size cutting tip with the oxygen turned down a little lower than for regular cutting, so you don't blow through too much. Just heat the weld red hot and use just enough cutting oxygen to blow the metal away. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.