Posted by SGF on November 14, 2007 at 03:01:51 from (76.0.158.9):
In Reply to: Re: Fluids idea posted by Janicholson on November 13, 2007 at 10:02:23:
Both your points are valid but I think there is more to it than that. Here is one example. My Ford 641's manual calls for 20 wt motor oil in the engine. If you look around the Web, you'll find recommendations for 20 and 30 wt detergent and non detergent oil, 10W30, and 10W40 multi viscosity oils. Apparently they all work, as folks recommend them.
I suppose my goal is to obtain some consensus of opinion. Like with most things, the fluid recommendation used by most people is likely the best choice. In another example, I wanted to run the same hydraulic oil in my tractor and Wagner loader. That way, other than engine oil I only have one fluid to worry about. The looming question is what to run, or what works best. Don-Wi’s point about the Oliver being less picky is a perfect supporter of my point, when he mentions one brand being pickier than the other. That is knowledge that comes with (likely) a wealth of experience. I novice trying to learn what to use may get conflicting information which could lead to costly mistakes.I know we will never get everyone to agree on what fluid is best, but I think it could be narrowed down more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.