Posted by Old Ford Mechanic on November 04, 2007 at 18:07:22 from (67.72.98.113):
Good evening,T'm thinking about changing from an LP gas central heating and cooling unit to an electric heatpump for my home.The old gas unit was installed in 1989.We have only been using the cooling side for the last dozen years or so.I had a problem with a freon leak a couple of years back.I repaired a leaking schrader valve and recharged the unit and have not had a problem since.We installed Infared wall heaters when we stopped using the heat side on the unit.The wall units were more cost friendly and did a great job of heating the house.But the LP gas prices now have gotten me to thinking that maybe i could use electric heat and reduce the yearly cost a little.And with the age of the existing unit now might be the time to switch.The heatpump would have the heatstrips but,the winters here are not usually very cold.So i don't believe the strips would be utilized that much.The gas prices are ranging for $2.19 to $2.49 per gallon here now.And i usually average 300 gallon per year.As i said the old unit is in its 19th.year of operation.And we are talking about 3 ton units.The house is a single level over crawlspace.The attic has 15" of blown insulation.Our winters usually have nightime temps in the mid to high 20's.An artic blast might sometimes lower that to the mid teens for a couple of nights.I am in Alabama.What do you guys think?Good move or not?By the way i will keeping the infared wall units for backup in case of power failure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
