Re: farmall head gasket

Posted by High Octane on October 22, 2007 at 20:17:53 from (4.224.78.118):

In Reply to: farmall head gasket posted by 1965lonewolf on October 22, 2007 at 10:40:37:

Dont go thinner than .032. Ive done as thin as .020 out of copper, they did seal, but the piston/head clearence is tight, too tight. Also, if your blocks still run sleeves, they have a sleeve standout above the block, so the copper wont crunch in and seal up. If a stock gasket can be used, use it, proper assembly and break in will gain as much torque as the extent of a thin gasket. .032 will still keep the clearences with little work, it does raise the cyl pressure,,,, Ive seen up to a 20 psi gain with the .020 gasket, probably 15 more with a .032 VS the stock gasket. Engine had flat top 4 inch bore pistons, they hit at .020, (imagine that LOL) tapped when it warmed up, quiet when it was cold,, so it was at the tipping over the borderline of tight. If you have done cyl head work, say new valve job, milled up to .100 off the head, new gaskets, good carb, new intake, good IGN, you will make more power than what you had before, dialing it all in for good relaible tractor! Hope this helps. www.thetractorshop.com

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]