The way this Kentucky hillbilly has it figured is; any thing you can do to break the 'pan' is better than what you have. I don't own a bulldozer or a tractor capable of yanking a 3 shank subsoiler. But, I do own a single shank subsoiler and a tractor that can pull it. I can't see anything but beneficial results from subsoiling my ground. By all means do it when the earth is dry.....and with the drought we had this year...it was a perfect time to subsoil. Very little 'subsoil' is brought to the surface.....I don't know what the other fellow is referring to. BUT, the fracture effect of the compacted soil strata is terribly obvious! My subsoiler shank will penetrate about 18" to 24" and it will make my 60 horse 4 WD Deere grunt to pull it. You can see the ground swell and lift about 3 feet on each side of the shank slit! I also have a 4"-5" 'mole ball' trailing my subsoiler. I made it from a giant ball bearing I found. This mole ball..(some call it a cannon ball!) will leave...at least in theory..a tunnel for water drainage. I think it also helps fracture the lower soil strata, allowing for better root penetration. Compaction shouldn't be much of a factor if you are subsoiling DRY ground. Anybody with any sense at all, knows better than get in a wet field.
If the fall rains have set in where you are, it may be too late to subsoil your ground. I still think under the right conditions (dry) any subsoiling is better than no subsoiling.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
