Ok, Brian! I finally found the Float Spring Attachment Operators Manual. It says to adjust the springs until 150 pounds of lift, on a spring type scale, is required to manually lift the head up. It says never to have more than a 3 1/2 inch gap between the spring casting and the front channel iron, or the springs could bottom out. It says you should start the adjustment process with the head tight on the ground, with enough pressure to open up a 1 1/2 inch gap between the channels at rest. ( I don't remember ever doing this 1 1/2 inch thing, but maybe I did) Says to tighten up the longest springs first. If you can't get the adjustment to 150 pounds, you have to add or remove springs. Book says 4 springs on a 6600 with a 13' pickup reel. 5 springs with a 14' pick up reel. I know mine 213 flex had 5 springs. If you want, you can call me this evening, after 7 pm (Central time) and I could read you some more of this info. 309-668-3247.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.