Posted by TyTX on October 08, 2007 at 18:50:59 from (65.91.198.63):
In Reply to: Re: removing head posted by FarmallJoe on October 08, 2007 at 17:28:44:
Don't neglect to have the head surfaced while it is in the shop. They will remove a small about of metal to assure the surface is flat. Last time I had heads surfaced the shop only took off .006" to make them true.
If you neglect to true the heads they can blow the new head gasket in short order.
Be sure to clean all the bolt threads and run a clean-out tap into the bolt holes. Debris on the threads or in the holes will alter the torque.
If you are using composition head gaskets, put them on dry. If you are using the old metal gaskets (the whole thing is metal not just a ring around the cylinder part) then use a gasket sealant like Copper Plate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.