I own a 650 like yours and a couple of years ago it got to running poorly and went to pulling down and then smoking some and finally quit. It needed the injection pump rebuilt. The pump as you say is almost a built in. However, do not despair. It is not too bad to remove/replace. The main thing you need to do is not to get in a hurry and also clean the area around the pump very-very good and keep it clean while dealing with the injection pump and injectors. Take the lines loose from the pump and the injector and mark them so you can get them back right. DO NOT BEND THEM!!! There are about 4 nuts holding the pump into the governor housing take them off and very carefully tap and shake the pump till it loosens and lift it out. Be sure to keep the shim pack between the governor housing and the pump intact because these set the timing. Measure the thickness of them and then buy the shim package from John Deere and use the EXACT same thickness of shims when replacing the pump. I sent my injectors as well to be check/reconditioned at the same time. They probably both need inspecting or repairing. Be sure you hold the line nuts and the fitting it tightens to when reinstalling them. Bleed everything all the way to the injector itself before trying to crank it. I installed a small electric fuel pump in the line on my tractor and also installed a furnace oil filter unit that uses a Wix # 4104 filter in addition to the regular filter with the glass bowl. I got 1250 hrs out of my pump before rebuilding it and the price for rebuilding pump and injectors was over $650.00. It has been a good dependable tractor though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
