Posted by Bob on September 25, 2007 at 19:09:21 from (69.178.229.154):
In Reply to: 1951 Ford 8N posted by RDunster on September 25, 2007 at 18:52:52:
There should be 3/4" "free-play" (movement of the clutch pedal before the throwout bearing contacts the clutch release fingers to begin releasing the clutch).
If you have about that much free-play, something else is the problem.
The clutch MAY be gummy and oil-soaked if the engine's rear main seal or the tranny's front input shaft seal are leaking. The linings on the clutch disc could be coming apart from age, or there could be moisture and rust or other debris in there making the clutch stick.
(There is a drain hole in the bottom of the clutch housing with a cotter key loosely fitted into it, to vibrate around, and keep the hole free of dirt. If this has become gummed up, oil and or water can accumualte in the clutch housing. Take a look under there to be sure the key is there, loose in the hole, and the drain hole is "open".)
Some folks have had success with using brake cleaner sprayed as well as possible on the clutch by using the (bent) "straw" on a can of "brake clean" inserted into the hole where the starter goes, spraying the backside of the flywheel.
Others even drill a small hole in the clutch housing, in line with the lined plate, and "hosing it down" with brake cleaner through there.
If neither of these options appeal to you, or work for you, for a proper repair the tractor will have to be split, and the clutch rebulit, repaired, or replaced, as needed.
For more information, surf over to the "N" Board on this site and ask any questions you may have, and/or search the archives to see what folks with similarproblems have done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
