Posted by INCase on September 24, 2007 at 19:29:29 from (71.115.81.215):
Ok. finally got the old girl Case 800 running with new LP heads and newer/better manifolds (gas).
Here"s the PRoblem... now that its quieter I can hear a pretty good rattle/knocking/clatter sound in the lower end. Its not real loud but can be heard especially on the right side not as loud on the left. Its mainly near the front of the engine near #1. I pulled the wires off the plugs as I read in an ooold post that that can help determine if its a rod knock. The noise did not change at all with the spark plugs disabled. The soundis also still there with an increase in speed (just sounds like a faster rattle/clatter). I did drain the oil. The 1st oil to come out was kinda watery/sluggy mix and is somewhat black/grayish in color with a little gas smell. It had cracked heads and I knew it was getting some water in the oil that way and do not know how long the previous owner ran it that way. I pulled the pan and pulled #1 and #4 caps off. The picture is from the #1. #4 looks a little better (less grooves).
What does a rod or main bearing knock sound like? Would bad cam bearings make that sound?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
